Results 1 - 10 for Pounds per square inch

House Bill 3360
(d) Pressure vessels being operated at gauge pressures of less than 15 pounds per square inch and which are equipped with a pressure relief device set to open at a pressure no ...
http://www.leg.state.or.us/07reg/measpdf/hb3300.dir/hb3360.en.pdf
open  pop

Volumes of Carbon Dioxide (CO2) Pounds per square inch (psi)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 30 1.821.922.032.142.232.362.482.602.702.822.933.02 31 1.781.882.002.102.202.312.422.542.652.762 ...
http://www.homebrew.com/pdfs/CO2chart.pdf
open  pop

Metric Conversion Table
... 0.4788026 pounds per square foot pascals 47.880259 pounds per square foot pounds per square inch 0.006944 pounds per square inch atmospheres 0.068046 pounds per square inch bars 0.0689476
http://www.longhorntrailers.com/pdf/Metric-Conversion-Table.pdf
open  pop

CONVERSION FACTORS
... Pounds per square inch 2.0353 Inches of mercury Pounds per square inch 51.697 Millimeters of mercury Pounds per square inch 0.0703 Kilograms per square centimeters Pounds per square inch 6 ...
http://www.water-research.net/Waterlibrary/watermanual/conversion_factors.pdf
open  pop

Pipeline Accident Brief
The pipeline had been installed on August 9, 1961, as a distribution main pipeline; it had a maximum allowable operating pressure of 30 pounds per square inch, gauge (psig) and was ...
http://www.ntsb.gov/publictn/2008/PAB0801.pdf
open  pop

Explanation of Physical Test Procedures
It is the ratio of the breaking strength (flexural strength) in pounds per square inch to the deformation (inches per inch) at break, and the value is expressed in pounds per square ...
http://www.polyspec.com/Lit/M_Physical%20Test%20Procedures%20-%201103.pdf
open  pop

POUNDS PER CUBIC INCH
POUNDS PER CUBIC INCH Aluminum Copper Alloys Nickel Alloys Alloy lb/cu inAlloy lb/cu inAlloy lb ... x (D- d ) x t x w =lbs per piece Round Rods D 2 x9.42 x w =lbs per foot Square Bars D 2 x12 x w ...
http://www.tandt-materials.com/LinkClick.aspx?fileticket=DL1z0xk7U3w%3d&tabid=77
open  pop

Materials Laboratory Study 05-124
Report No. 05-124 Page No. 4 3,000 pounds per square inch after heating to 260 degrees Fahrenheit and would reach 3,300 pounds per square inch after heating to 315 degrees Fahrenheit.
http://www.ntsb.gov/Events/2006/WilmerTX/Exhibits/337590.pdf
open  pop

Industrial / Air & Gas Compressor Services Sales —Service—Parts ...
Generally expressed in terms of: PSIG — Pounds per square inch gauge. Gauge pressure is the pressure above local atmospheric pressure. PSIA— Pounds per square inch absolute.
http://best-aire.com/Best%20Aire%20Linecard.pdf
open  pop

WATER HEAD IN FEET AND EQUIVALENT PRESSURE in Pounds per Square Inch
Water Head.qxd
http://ppt-hose-tech.com/Downloads/Water%20Head.pdf
open  pop

Featured Results: